Page 1 of 1
Posted: Sun Aug 05, 2007 1:27 pm
by rebush
I'm going to attempt to install a B&G H1000 autopilot myself. I am look for advice as to where to mount the hydraulic ram. Pictures of an existing installation would be greatly appreciated.
Posted: Mon Aug 06, 2007 9:53 am
by blur
I'll do this myself this winter, but here are some pics I took aboard "JJ Flash". Hope this helps:
http://www.flickr.com/search/?q=bgmount ... 3138%40N00
Posted: Mon Aug 06, 2007 5:54 pm
by rebush
This is excellent, exactly what I was looking for. I was thinking that the box structure that surrounds the hot water heater would be a good mounting point but I wasn't sure about its strength. Thanks
Posted: Wed Aug 08, 2007 2:20 pm
by jim
What is the measurement from the center of the rudder post to the center of the pin on the rudder arm? I used 10 inches and don't like how short the steering radius has become. I used 10" in order to accommodate the linear rudder reference unit.